- Synthesis of Tungsten Heavy alloy Nanocomposite Powder by Ultrasonic-milling Process
-
Seung-Chul Lee, Chang-Woo Lee, Sung-Soo Jung, Berm-Ha Cha, Jai-Sung Lee
-
J Korean Powder Metall Inst. 2007;14(2):101-107.
-
DOI: https://doi.org/10.4150/KPMI.2007.14.2.101
-
-
21
View
-
1
Download
-
2
Citations
-
 Abstract
 PDF
- Ultrasonic-milling of metal oxide nanopowders for the preparation of tungsten heavy alloys was investigated. Milling time was selected as a major process variable. XRD results of metal oxide nanopowders ultrasonic-milled for 50 h and 100 h showed that agglomerate size reduced with increasing milling time and there was no evidence of contamination or change of composition by impurities. It was found that nanocomposite powders reduced at 800°C in a hydrogen atmosphere showed a chemical composition of 93.1W-4.9Ni-2.0Fe from EDS analysis. Hardness of sintered part using 50 h and 100 h powder samples was 399 Hv and 463 Hv, respectively, which is higher than the that of commercial products (330-340 Hv).
-
Citations
Citations to this article as recorded by  - Grinding behavior of WO3, NiO, Fe2O3 by ultrasonic milling parameters control and preparation of nanocomposite powder
Keunhyuk Ryu, Kun-Jae Lee
Advanced Powder Technology.2020; 31(9): 3867. CrossRef - Investigation on Size Distribution of Tungsten-based Alloy Particles with Solvent Viscosity During Ultrasonic Ball Milling Process
KeunHyuk Ryu, HyeongSub So, JiSeok Yun, InHo Kim, Kun-Jae Lee
Journal of Korean Powder Metallurgy Institute.2019; 26(3): 201. CrossRef
|
kpmi
